January 25, 2002, Newsletter Issue #32: Changing the Oil

Tip of the Week

Your RV generator requires maintenance just like any engine. One of the tasks you must perform is to change the oil. You should refer to your owner’s manual for exact procedures, but general you can follow these steps:
1. Run the generator to bring it to operating temperature.
2. Locate the oil fill cap and remove it.
3. Locate the oil drain/valve and remove/open it. Make sure to collect the oil in a suitable container and dispose of it properly.
4. After the oil is done draining, reinstall the oil drain/valve and reinstall/close it.
5. Locate the oil filter and remove it. (Remember to put a container or some disposable rags down to catch any drips. Dispose of the oil filter properly.)
6. Put a light film of oil on the new oil filter gasket and install it. Usually turning the filter and additional 1/2 turn after the gasket touches the base is sufficient, but check you owner’s manual for exact specs.
7. Add oil to the full level on the dipstick. Start the generator and check for leaks.

About LifeTips

Now one of the top on-line publishers in the world, LifeTips offers tips to millions of monthly visitors. Our mission mission is to make your life smarter, better, faster and wiser. Expert writers earn dough for what they know. And exclusive sponsors in each niche topic help us make-it-all happen.

Not finding the advice and tips you need on this RV Tip Site? Request a Tip Now!


Guru Spotlight
Patricia Walters-Fischer